T1517
Time delay switch

Voltage is applied to the unit at all times via the black and white wires. When the switch is placed in the "On" position, power is applied to the Lamp and Fan Output. When the switch is placed in the "Timed" position, the power is removed from the Lamp Output and the Fan Output stays on for the preset delay time. After the delay time the power is removed from the Fan Output. Should the switch be placed in the "On" position during the delay time, the timer will be reset and both outputs will be "On" as defined above. Should power be interrupted, when in the "Timed" position, the timer will be reset and when power is reapplied the Fan Output will be "On" for the preset delay time after the power is re-applied.

RFM-100
Dryer Booster Fan Monitor Light

RFM-100 is installed in series with dryer booster fan. In the event of booster fan failure during operation, the fan monitor light goes "OFF". In this situation, Do Not operate your clothes dryer. Contact your qualified service personel. For more information contact factory.

RH100
RH100 (Humidistat/Dehumidstat )

CVC
Air Volume Controller

The installation of a constant volume control damper in a ventilation system has some advantages compared with other control systems (control register, diaphragm, etc...) System regulation or calibration is not needed The air volume is always the same whatever the pressure variation in the ventilation system.

RF-100
Media Air Cleaner

The high efficiency air cleaner housing is easily installed with any type of forced air heating/cooling system. Standard sheet metal procedures are followed and no special tools are required. The Reversomatic air cleaner housing is mounted in the return air duct - horizontally, vertically, or at an angle as required. Continuous air circulation is recommended for best results. Set the furnace blower to run constantly.

Access Door
FLAT - ADF Series

The "ADF" Series are manufactured from 20 gauge satin coat steel for corrosion resistance and come with a screwdriver operated cam-lock. These doors are featured with round cornered flange invisible hinge and flush mounted door panel. They can be installed on drywall, masonry and tiles surfaces. Custom Sizes, powder coated finishing and various color options are available upon request.

Access Door
PROJECT - ADP Series

The "ADP" Series are manufactured from 20 gauge satin coat steel for corrosion resistance and come with a screwdriver operated cam-lock. These doors are designed to install on drywalls, masonry and tiled surfaces. Custom Sizes, powder coated finishing and various color options are available upon request.